![lenovo u460 graphic card benchmark lenovo u460 graphic card benchmark](https://www.notebookcheck.net/fileadmin/Notebooks/News/_nc3/IdeaPad_S540_6.png)
![lenovo u460 graphic card benchmark lenovo u460 graphic card benchmark](https://images.jagoeve.com/magictoolbox_cache/8c95d73fec130487c102a73bf1ab42ce/3/3/3318/thumb521x575/109591419/6-501.jpg)
Memory at c0000000 (64-bit, prefetchable) Ĭapabilities: MSI: Enable+ Count=1/1 Maskable- 64bit-Ĭapabilities: Power Management version 2Ġ0:16.0 Communication controller: Intel Corporation 5 Series/3400 Series Chipset HECI Controller (rev 06)įlags: bus master, fast devsel, latency 0, IRQ 42 Memory at d0000000 (64-bit, non-prefetchable)
LENOVO U460 GRAPHIC CARD BENCHMARK HOW TO
So, any ideas on how to fix this? Let me know if I forgot to post something.Ġ0:00.0 Host bridge: Intel Corporation Core Processor DRAM Controller (rev 02)įlags: bus master, fast devsel, latency 0Ĭapabilities: Vendor Specific Information: Len=0c Ġ0:02.0 VGA compatible controller: Intel Corporation Core Processor Integrated Graphics Controller (rev 02) (prog-if 00 )įlags: bus master, fast devsel, latency 0, IRQ 40 intel_backlight still works.ħ) Keys do not repeat (unless I do the "reset" above).Ģ) Extract and recompile the DSDT, fixing errors and warnings, compile custom kernel with new DSDT included.Ĥ) Looked to see if there was a BIOS update. If acpi_backlight=vendor, then acpi_video0 gets renamed to ideapad, and brightness can no longer be changed through there. This does not happen in an X session.Ħ) I can set the screen brightness through /sys/class/backlight/acpi_video0/brightness (0-10) and /sys/class/backlight/intel_backlight/brightness (0-4882). If ambient light conditions change, these messages start again.ģ) The characters appear in the console occasionally (thought it only seems to happen before the login prompt or after a shutdown signal).Ĥ) Occasionally I will get a system beep during boot (which may or may not be related).ĥ) This problem seems to insert invisible characters into stdin, so I cannot login in a tty (unless I do the aforementioned "reset"). If acpi_backlight=vendor, then nothing gets printed, though the tty console cursor does "blip" as if a normal key were pressed.Ģ) If acpi_backlight=legacy, the message "ACPI: Failed to switch the brightness" pops up in dmesg repeatedly until I do what I think "resets" the ALS, which is to press Fn+Down several times followed by Fn+Up several times.
![lenovo u460 graphic card benchmark lenovo u460 graphic card benchmark](https://i.ytimg.com/vi/IlV21-zr5NU/maxresdefault.jpg)
Also, if acpi_backlight=legacy, then the message "ACPI: Failed to switch the brightness" pops up in dmesg. Here are the symptoms:ġ) The brightness controls (Fn+Up/Fn+Down) don't affect the screen brightness. This is going to be a little hard to describe, so please bear with me. I have tried to figure this problem out ever since I first installed Arch a few months ago (coming from Fedora/Ubuntu where this never occured).